At Command Reference - INSYS 56k Small INT 2.0 Manual Manual

INSYS Modem 56k Small INT 2.0
15

AT Command Reference

Command
AT**
ATA
A/
AT\A<n>
AT*A<n>
AT&A<n>
AT%A<n>
Description
Start of the flash load function
Answer mode
The INSYS Modem 56k Small INT 2.0 modem is switched into response mode. This is
only effective in Germany, if the connected phone goes off-hook or if a call comes in.
Repeat the last command
The last command is repeated.
Select maximum MNP block size
Define maximum block size for error corrected MNP transmissions.
AT\A0 64 byte
AT\A1 128 byte (default)
192 byte
AT\A2
AT\A3 256 byte
Automatic call acceptance ON/OFF
AT*A0 Call acceptance is blocked, irrespective of S0
Call acceptance according to S0 (default)
AT*A1
Note: see also S-Registry 36, bit 7
Selective Call Answer On or Off
To evaluate selective call answer, the phone number must be transmitted (CLIP). The
following countries support the "CLIP" function:
Australia, Belgium, China, Denmark, Germany, Finland, Great Britain, Hong Kong, India,
Ireland, Iceland, Italy, Canada, Korea, New Zealand, The Netherlands, Norway, Austria,
Sweden, Singapore, Spain, Taiwan, USA.
AT&A1 Switches the selective call answer ON
AT&A0 Switches the selective call answer OFF (default)
The AT&A setting is saved in AT&W.
Send alarm text manually
Manual triggering of the message. After the message is sent, the device responds with
OK (success) or ERROR (failure).
Note: see also AT*V<n>
AT Command Reference
51