Remote Configuration Of The Insys Modem 56K Small Int 2.0 - INSYS 56k Small INT 2.0 Manual Manual

Functions
Configuration with AT commands
To turn the remote configuration on, use:
To enable the remote configuration, the
automatic call acceptance (e.g. after 2 ring
tones) must be activated.
Activate the error correction, for example, for
the INSYS Modem 56k Small INT 2.0 to auto-
matically dial the V.42LAP-M or MNP4 error
correction.
To enter a password for the remote configura-
tion, use the command:
Save the settings with:
12.12 Remote Configuration of the INSYS Modem 56k Small INT
2.0
Perform the remote configuration
In the following, we show how you can configure the INSYS Modem 56k
Small INT 2.0 remotely.
You will need a modem which you can use to establish a connection to the
INSYS Modem 56k Small INT 2.0.
You will need a terminal program.
1. Open your terminal program.
2. Establish a connection to the INSYS Modem 56k Small INT 2.0. Use the local
modem to dial the phone number of the INSYS Modem 56k Small INT 2.0
with ATD<phonenumber>.
The local modem establishes a connection.
3. After the connection has been established, enter **** (four asterisks). This will
switch you into remote maintenance mode.
If you set a password, you will now need to enter it.
After you successfully entered the password, the INSYS Modem 56k Small
INT 2.0 will send a prompt in form of an ">".
40
INSYS Modem 56k Small INT 2.0
AT*R1
ATS0=2
AT\N2
AT*C
AT&W