INSYS 56k Small INT 2.0 Manual Manual page 71

INSYS Modem 56k Small INT 2.0
Command
AT*V
AT*V?
AT*V<n>
AT*V<n>?
Description
Definition of the common alarm texts (collective message)
for simple alarm: Definition of the alarm text (maximum of 160 characters)
for pulse alarm: Definition of the common part of the alarm message (maximum
of 160 characters – within HSComm limited to 120 characters)
To the input AT*V the INSYS Modem 56k Small INT 2.0 responds with NEW TEXT: and
expects the input of the alarm text (completed with <CR>)
This command is not available in the remote operation mode.
Relevant commands: AT*V, AT*V<n>
AT&Z0
Query of the common alarm texts (collective message)
The common part of the alarm message is queried with the command AT*V?.
Definition of the variable alarm texts and phone numbers
Definition of the alarm texts and phone numbers for the SMS dispatch.
To the input AT*V1 to AT*V10 the INSYS Modem 56k Small INT 2.0 responds with NEW
TEXT: and expects an input in the format phone number,message<CR>
Phone number
change (only required for service number)
Message Alarm message (maximum of 80 characters)
For the transmission, the variable part (maximum of 80 characters) will be attached to
the common part (maximum of 160 characters) of the collective message. Of the
maximum of 240 characters, the first 160 characters are sent as SMS.
Relevant commands: AT*V<n>
AT&Z0
Query of the variable alarm texts and phone numbers
The variable part of the alarm message and the target phone number are queried with
AT*V1? to AT*V2?.
Definition of messages/phone numbers
Definition of the SMS service center
Enter without characters for accessing the ex-
Definition of messages/phone numbers
Definition of the SMS service center
AT Command Reference
71