Table of Contents
Advertisement
AT Command Reference
Command
AT\B<n>
AT%B<n>
AT%C<n>
52
Description
Send "break" to the other INSYS Modem 56k Small INT 2.0
For connections that were not error corrected the INSYS Modem 56k Small INT 2.0
sends a break signal to the other INSYS Modem 56k Small INT 2.0. The length of the
signal is: the specified parameter times 1/10 of a second.
For error corrected connections, the INSYS Modem 56k Small INT 2.0 sends a break sig-
nal according to the active error correction protocol without considering a parameter
specification.
If no connection is established or if a fax connection is active, an error message is dis-
played.
AT\B1
1/10 second break signal
2/10 second break signal
AT\B2
AT\B3
3/10 second break signal
AT\B4
4/10 second break signal
AT\B5
5/10 second break signal
6/10 second break signal
AT\B6
AT\B7
7/10 second break signal
AT\B8
8/10 second break signal
AT\B9
9/10 second break signal
Switch key abort on and off during connection
%B0
Key abort is active. Each character on the TX line will result in an
interruption of the connection setup (default)
%B1
Key abort is deactivated. A connection setup can not be interrupted
manually. A connection setup can only be terminated via DTR drop, in-
ternal canceling of the INSYS Modem 56k Small INT 2.0 (NO DIAL-
TONE, BUSY) or Timeout (NO CARRIER). (S-Registry 36 Bit 6)
Enable data compression
Enable/disable a data compression type
The INSYS Modem 56k Small INT 2.0 can only perform data compression for error cor-
rected connections.
AT%C0
No data compression enabled
AT%C1
MNP 5 data compression enabled
AT%C2
Enable V.42bis and V.44 data compression
Enable MNP 5 and V.42bis data compression (default)
AT%C3
INSYS Modem 56k Small INT 2.0
Advertisement
Table of Contents
Need help?
Do you have a question about the 56k Small INT 2.0 and is the answer not in the manual?