INSYS 56k Small INT 2.0 Manual Manual page 36

Functions
Configuration with AT commands
To activate the selective call acceptance, use
the command:
To switch the selective call acceptance off, use
the following command:
To display a complete list of stored phone
numbers for the selective call acceptance, use:
To delete a single storage location, overwrite
the storage location with an empty space after
the character "=".
To delete the entire phone list for the selective
call acceptance:
To store the phone number <nr> in the stor-
age location <n> , use:
The INSYS Modem 56k Small INT 2.0 checks the phone number sent via CLIP
for one of the stored numbers. The check starts on the "right", i.e. from the
end of the phone number submitted by CLIP. This makes it possible to recog-
nize a phone number, although a prefix such as "+49" or "0049" was placed
before the number. Also, the number for the detection can be made variable
with the help of wild cards. The stored phone numbers may not include any
separators, such as dashes between prefix and phone number.
For example, to permit the numbers
+49941686920, 0941686920, 0049941686920
as callers, just store 941686920 at the location
number 1.
For each variable digit in the phone number,
an asterisk * can be entered.
To keep the last two digits variable, e.g. to al-
low callers from extensions, use two (**) char-
acters.
36
INSYS Modem 56k Small INT 2.0
AT&A1
AT&A0
AT*N?
AT*N<n>=
AT*N99
AT*N<n>=<nr>
AT*N1=941686920
AT*N1=9416869**