Sharp AR-M455N Service Manual page 212

67
67-2
Purpose Operation test/Check
Function Used to check the operation of the parallel I/F of
(Purpose) the printer. (This simulation is for production only,
and requires a special tool for execution. Not used
in the market.)
Section MFP controller
Item Operation
Operation/Procedure
(Display message)
WAITING Waiting
READY Check start OK
OK Check end (Normal)
STAGE*NG Check end (Error in stage *. *: 1 - 11)
SIMULATION 67-2
CENTRO PORT CHECK.
CENTRO PORT: READY
lWith READY displayed,
press [START] key.
SIMULATION 67-2
CENTRO PORT CHECK.
CENTRO PORT: OK (or STAGE7
67-11
Purpose Setting
Function Used to set YES/NO of the parallel I/F select
(Purpose) signal of the printer.
Section MFP controller
Item Operation
Operation/Procedure
1) Enter the number corresponding to the select IN signal YES/
NO setting with 10-key.
Item
0 OFF
1 ON
2) Press [START] key.
When the printer parallel I/F is used and a trouble is generated in
the communication between the PC and the printer, change the
setting of this simulation.
SIMULATION 67-11
CENTRO SELECT IN SIGNAL SETTING. SELECT 0-1, AND PRESS
START.
0. OFF
1. ON
Interface/Communication
Press [CUSTOM SETTINGS] key.
NG)
Interface/Communication
Default
1
AR-M355N/M455N SIMULATION 9 - 86
67-16
Purpose Operation test/Check
Function Used to check the operation of the network card.
(Purpose)
Section MFP controller
Item Operation
Operation/Procedure
During check, "CHECKING" is displayed. When check is com-
pleted normally, "OK" is displayed. In case of an error, "NG" is dis-
played.
(Display message)
CHECKING
OK
NG
SIMULATION 67-16
NETWORK INTERFACE CARD CHECK.
NIC: CHECKING
Check end Press [CUSTOM SETTINGS] key.
SIMULATION 67-16
NETWORK INTERFACE CARD CHECK.
NIC: OK (or NG)
Interface/Communication
Checking
Check end (Normal)
Check end (Error)