Sharp AR-M455N Service Manual page 194

62-3
Purpose Operation test/Check
Function Used to check the operation of the hard disk (read/
(Purpose) write). (All areas check)
Section MFP controller (HDD)
Item Operation
Operation/Procedure
1) Select YES/NO of hard disk read/write check.
1 YES Execution
2 NO Cancel
2) Press [START] key.
During testing, "EXECUTING" is displayed. When test is com-
pleted normally, "OK" is displayed. If not, "NG" is displayed.
SIMULATION 62-3
HDD R/W TEST(ALL).
ARE YOU SURE?
1. YES
2. NO
Press [START] key.
SIMULATION 62-3
HDD R/W TEST(ALL). EXECUTING···.
Completion
SIMULATION 62-3
HDD R/W TEST(ALL). OK. (or NG)
62-6
Purpose Operation test/Check
Function Used to check the operations of the hard disk.
(Purpose) (The self diag operation of the SMART function is
executed.)
Section MFP controller (HDD)
Item Clear
Operation/Procedure
1) Select the number corresponding to the self diag check mode.
1 SHORT SELF-TEST
2 EXTENDED SELF-TEST
2) Press [START] key.
During the self diag operation, "EXECUTING" is displayed.
If the self diag is completed normally, "0" is displayed. If not, any
value but 0 is displayed.
1
Press [CUSTOM SETTINGS] key.
Partial test
All areas test
AR-M355N/M455N SIMULATION 9 - 68
SIMULATION 62-6
SMART OFFLINE TEST.
1. SHORT SELF-TEST
2. EXTENDED SELF-TEST
Press [START] key.
SIMULATION 62-6
*. EXECUTING···.
Completion
SIMULATION 62-6
*. COMPLETE.. (result: 0)
* = SHORT SELF-TEST, EXTENDED SELF-TEST
62-7
Purpose Operation test/Check
Function Used to check the operations of the hard disk.
(Purpose) (The result of the self diag operation of the
SMART function is printed out.)
Section MFP controller (HDD)
Item Clear
Operation/Procedure
1) Enter 1 with 10-key.
0 TRAY SELECT Tray select auto only (Selection inhibited)
1 PRINT START Print start
2) Press [START] key.
The result of the hard disk operation check (the self diag operation
of the SMART function) is printed out.
SIMULATION 62-7
SMART ERROR LOG PRINT OUT. SELECT SETTING, AND PRESS
START.
0. TRAY SELECT :AUTO ONLY
1. PRINT START
Select 1 and
press [START] key.
SIMULATION 62-7
SMART ERROR LOG PRINT OUT. EXECUTING···
0. TRAY SELECT :1
1
Press [CUSTOM SETTINGS] key.
1
Press [CUSTOM SETTINGS] key
or [START] key.
0