Riding Instructions; Checks And Maintenance Measures When Preparing For Use; Starting - Husqvarna 125 XC-W 150 2017 Owner's Manual

9

RIDING INSTRUCTIONS

9.1

Checks and maintenance measures when preparing for use

Info
Before every trip, check the condition of the vehicle and ensure that it is safe to operate.
The vehicle must be in perfect technical condition when it is being operated.
–
Check the gear oil level. (
–
Check the electrical system.
–
Check the front brake fluid level. (
–
Check the rear brake fluid level. (
–
Check the front brake linings. (
–
Check the rear brake linings. (
–
Check that the brake system is functioning properly.
–
Check the coolant level. (
–
Check the chain for dirt. (
–
Check the chain, rear sprocket, motor sprocket, and chain guide. (
–
Check the chain tension. (
–
Check the tire condition. (
–
Check the tire air pressure. (
–
Check the spoke tension. (
Info
The spoke tension must be checked regularly as incorrect spoke tension will strongly impair riding safety.
–
Clean the dust boots of the fork legs. (
–
Bleed the fork legs. (
–
Check the air filter.
–
Check the settings of all controls and ensure that they can be operated smoothly.
–
Check all screws, nuts, and hose clamps regularly for tightness.
–
Check the fuel level.
9.2

Starting

Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when running the engine.
–
Use an effective exhaust extraction system when starting or running the engine in an enclosed space.
Note
Engine damage High revving speed with a cold engine negatively impacts the lifespan of the engine.
–
Always run the engine warm at a low speed.
Info
If the motorcycle does not start easily, there may be old fuel in the float chamber. The easily ignitable components of the fuel
evaporate during lengthy periods of disuse.
When the float chamber is filled with fresh, ignitable fuel, the engine will start immediately.
Condition
The motorcycle was stationary for more than 1 week.
–
Empty the carburetor float chamber.
–

Turn handle of the fuel tap to the ON position. (Figure V00326-10
Fuel can flow from the fuel tank to the carburetor.
–
Take the motorcycle off of the stand.
–
Shift gear to neutral.
Condition
The engine is cold.
p. 111)
p. 77)
p. 82)
p. 79)
p. 83)
p. 100)
p. 68)
p. 69)
p. 88)
p. 88)
p. 89)
p. 51)
p. 51)
( p. 111)
p. 70)
p. 17)
35