Datamax H Class Operator's Manual page 75

SERIAL PORT C
BAUD RATE
1200 BPS
2400 BPS
4800 BPS
9600 BPS
19200 BPS
28800 BPS
38400 BPS
PROTOCOL
BOTH
SOFTWARE
HARDWARE
NONE
PARITY
NONE
ODD
EVEN
DATA BITS
7
8
STOP BITS
1
2
SERIAL PORT D
BAUD RATE
1200 BPS
2400 BPS
4800 BPS
9600 BPS
19200 BPS
28800 BPS
38400 BPS
PROTOCOL
BOTH
SOFTWARE
HARDWARE
NONE
When equipped with a GPIO Card, this controls the RS-232
communications settings for the COM C (J4) port, as follows:
Sets the serial communication rate:
1200 bits per second
2400 bits per second
4800 bits per second
9600 bits per second (Default Setting)
19200 bits per second
28800 bits per second
38400 bits per second
Sets the data flow control (handshaking) method, where:
XON/XOFF and CTS/DTR are used. (Default Setting)
XON/XOFF is used.
CTS/DTR is used.
Flow control is not used.
Sets word parity, where:
Parity is not used. (Default Setting)
Odd parity is used.
Even parity is used.
Sets word length, where:
A seven bit word is used.
An eight bit word is used. (Default Setting)
Sets the number of stop bits, where:
One stop bit is used. (Default Setting)
Two stop bits are used.
When equipped with a GPIO Card, this controls the RS-232
communications settings for the COM D (J3) port, as follows:
Sets the serial communication rate:
1200 bits per second
2400 bits per second
4800 bits per second
9600 bits per second (Default Setting)
19200 bits per second
28800 bits per second
38400 bits per second
Sets the data flow control (handshaking) method, where:
XON/XOFF and CTS/DTR are used. (Default Setting)
XON/XOFF is used.
CTS/DTR is used.
Flow control is not used.
67