Datamax H Class Operator's Manual page 119

Displayed
Message
This is the normal
operating mode of the
READY
printer.
REMOVE In order to proceed,
RIBBON ribbon must be removed
PRESS ANY KEY and then a key pressed.
Changes require
SAVE
confirmation before
CHANGES?
exiting the menu.
The operation was
SUCCESSFUL successfully executed,
PRESS ANY KEY but a key must be
pressed to continue.
The power switch has
SYSTEM been switched into the
INITIALIZING ON position, or a soft
reset has occurred.
SYSTEM RESET
The printer is resetting.
IN PROGRESS
The printer is not
UNCALIBRATED
calibrated.
WAITING FOR A printer is waiting to
DATA receive data.
WAITING FOR A label is waiting to be
SIGNAL printed.
A batch print job is in
XXXX OF XXXX
PRINTING process.
Description
The printer is waiting, ready to receive label
formats, downloads, etc.
The TEST Button was pressed and held or
CLEAN HEAD NOW was selected with ribbon
installed in the printer.
The printer is waiting for you to press YES to
proceed with these changes or NO to revert to
the previously saved settings.
The TEST Button was pressed and held or
CLEAN HEAD NOW was selected.
This message occurs during a power-up or soft
reset condition (following a SYSTEM RESET
IN PROGRESS message).
The printer has been reset via the host system
or through the User Interface.
Calibration must be performed.
The GPIO option has been enabled; a Start of
Print signal has been received; and, the printer
awaits label data from the host to proceed.
The GPIO option has been enabled and the
printer awaits the Start of Print signal to be
supplied from the GPIO card to proceed.
The printer is updating the printing status --
showing beginning batch total (represented by
the first XXXX number) and the remaining label
count (represented by the second XXXX
number).
111
Cause(s)
Note: If changes have been made that require a
reset, it will automatically be invoked.