Datamax H Class Operator's Manual page 121

Warning Messages
Displayed for about three seconds, these low-priority messages are meant to alert you to a
potential problem or pending change in configuration. Use the table below to locate the
message that was displayed by the printer, follow the row over to find a description of the
problem, and then a possible solution. If you have questions, contact a qualified technician or
Datamax Technical Support.
Displayed
Message
24V OUT OF
The printer has detected a
TOLERANCE
drop in the 24-volt power
supply.
DOT FAILURE
Defective printhead
elements have been
detected.
GAP MODE
Only a small difference
WARNING LOW
BACKING exists between the
measured 'empty' and 'gap'
media sensor readings.
GOODBYE
Power has been removed
and printer shutdown is in
progress.
Printer Warning Messages
Description
113
Possible Solution(s)
No action is required. If the problem
continues, cycle the power 'Off' and 'On.'
Replace the printhead if print quality
becomes unacceptable.
No action is required. During calibration,
labels mounted on a transparent liner or
notched media may give this indication. A
slight delay in the 'Out of Stock' message
(after the media supply is emptied) may be
experienced.
AC line voltage has been lost. The power
switch was turned OFF or the line fuse has
blown. If unable to restore power using the
power switch, try moving the printer to
another location and if the condition persists,
call for service.