Alert Prompts And Condition Messages - Datamax H Class Operator's Manual

Alert Prompts and Condition Messages

Alert Prompts appear when an operator action is required, while Condition Messages are
generated to indicate an operational state of the printer.
Displayed
Message
ACCESS DENIED Your entry is refused.
CALIBRATING
CANCEL BATCH
ENTER KEY =
YES
CANCEL
REPRINT
ENTER KEY =
YES
CLEARING
FAULTS
DMXNET
INITIALIZING
ENTER
PASSWORD
0 - - -
INVALID ENTRY
NOT INSTALLED
OFFLINE
PAUSED
PRINTHEAD
CLEANING
Prompts and Condition Messages
Description
Media calibration is
being performed.
The remaining labels in
the current batch will not
be printed if the ENTER
Key is pressed.
The current label will not
be reprinted if the
ENTER Key is pressed.
(Any labels remaining in
the batch will be printed.)
The printer is trying to
clear a fault condition.
This is a normal power-
up and soft reset
condition when equipped
with the DMXNet or
DMXrfNet option.
This is the password
gateway.
An invalid number or
variable has been
entered.
The item or feature
selected is not present.
The printer is in Menu or
Test Mode.
The printer is in a
paused state.
Printhead cleaning is in
progress.
You are attempting to enter a secured menu,
but have input an invalid password.
The FEED Key was pressed and held.
The CANCEL Key or the TEST Button was
pressed during a batch job.
The CANCEL Key or the TEST Button was
pressed during the fault handling process.
The FEED Key was pressed after a fault.
The network card is initializing. Depending
upon the programmed settings, this process
can take a few minutes.
You are attempting to enter a secured menu
and the correct four-digit password must be
entered. (Use the UP and DOWN Buttons to
input the numbers, the RIGHT Button to
advance the cursor and, after the password has
been entered, the EXIT Key to continue.)
The number or variable is out of range or not
valid for the setting or selection.
The selection is not installed or cannot be
detected by the printer.
The Menu or Test Button has been pressed.
The PAUSE Key has been pressed or Pause
Mode has been selected.
The TEST Button was pressed and held or
CLEAN HEAD NOW was selected.
110
Cause(s)