Password Protection - Minicom Smart CAT5 Switch 16 IP Operating Manual

Password protection

When the Smart system is password protected, the Control software behaves in
exactly the same way as the OSD. You must type in the required password to
access the Control software. The access you gain depends on the security status –
exactly as with the OSD.
To change the security access, close and reopen the Control software, and type in
the different password.
Administrator (Status A)
The Administrator can:
·
Set and modify all Passwords and security profiles
·
Fully access any computer
·
Use all functions
Supervisor (Status S)
The Supervisor can:
·
Fully access any computer
·
Scan computers.
User (Status U)
There are 6 different Users in the Smart 16 IP system. Each User has a Profile that
defines the access level to different computers. There are 3 different access levels.
These are:
·
Y – Full access to a particular computer
·
V –Viewing access only, to a particular computer (No keyboard/mouse
functionality)
·
N – No access to a particular computer
The Administrator defines the desired access levels of each User Profile. This is
done in the Setting box. By default the User Profile settings are full access.
OPERATING GUIDE
76
.