Mouse Synchronization; Mouse Mode Double/Single - Minicom Smart CAT5 Switch 16 IP Operating Manual

Hint. Always press the Auto Adjust video button
computer. The screen should be inside the borders of Remote Control window. If
the video doesn't synchronize properly or there is a lot of incoming traffic, reset
all modes and synchronize video again to improve video transfer.
36.

Mouse synchronization

There are two ways to synchronize the host and remote mice:
(a) Choose Options / Mouse Handling / Fast Sync. This corrects a temporary,
but fixed skew.
(b) Intelligent Sync. If the fast sync doesn't work or the mouse settings have been
changed on the host system use the Intelligent Sync option.
Note! Intelligent Sync only works when "Auto Mouse speed" is selected in
Keyboard & Mouse settings, see page 19.
To do so:
1. Ensure the picture is correctly adjusted, Click Auto Adjust or manually correct
the picture using the Video Settings.
2. Choose Options / Mouse Handling / Intelligent Sync.
Pressing
the video mode has recently changed.
Note! For the intelligent sync to work, the picture MUST be correctly adjusted.
Use the auto adjustment function or the manual correction in the Video Settings
panel to adjust the picture. The video must also be of sufficiently good quality.
37.

Mouse mode double/single

The information above applies to the Double Mouse Mode, where remote and
host mouse pointers are visible and need to be synchronized. There is also the
Single Mouse mode. In this mode only the host mouse pointer is visible.
Single Mouse mode needs a Sun Java Virtual Machine 1.3 or later.
Select the mode in the remote console – see Figure 38.
From the Options menu choose Mouse Handling/Mouse Mode/ Single Mouse
Mode. Or press
can be controlled directly.
OPERATING GUIDE
usually leads to a fast sync, except when the KVM port or
from the Control Buttons toolbar. The host mouse pointer
.
before operating the
54