Steering Post Cover/Instrument Pod - Arctic Cat ATV 250 Utility 2009 Service Manual

5. Install the fuse block, start-in-gear relay, and the
CDI; then install the body mounting cap screw
into the bottom of the battery box.
6. Install the battery and battery hold-down strap;
then connect the positive battery cable and the
negative battery cable.
NOTE: Always install the positive cable first; then
install the negative cable.
7. Install the seat making sure it is latched securely.
INSTALLING (250 Utility)
1. Place the front and rear fenders into position on
the frame and secure with the existing hardware;
then install the gas tank cover. Tighten all fasten-
ers securely.
2. Connect the headlight and taillight connectors;
then install the shift knob.
3. Making sure the locating tabs engage the appropri-
ate slots in the fenders, install the side panels.
4. Install the mud guards and secure to the fenders
and foot rest supports with the existing hardware.
Make sure all locating tabs are appropriately
engaged with the fenders and side panels.
Back
KM340A
KM789A
Back to TOC
5. Install the front center cover; then install the front
and rear racks. Tighten all fasteners securely.
6. Install the battery; then connect the positive bat-
tery cable, negative battery cable, and battery
hold-down strap.
NOTE: Always install the positive cable first; then
install the negative cable.
7. Install the battery cover; then install the seat mak-
ing sure it locks securely in place.
Steering Post
Cover/Instrument Pod
REMOVING (DVX 300)
1. Remove the two reinstallable rivets on the rear of
the steering post cover; then lift up and push the
assembly forward to remove.
2. Disconnect the wire connectors from the indicator
lights and from the ignition switch.
REMOVING (250 Utility)
1. Remove the reinstallable rivet on the front of the
instrument pod and the two cap screws on the rear;
then lift the assembly off and disconnect the
speedometer cable.
2. Remove the self-tapping screw securing the LCD
gauge assembly to the instrument pod; then
remove the LCD gauge.
NOTE: The LCD gauge is not a serviceable com-
ponent. If any functions are incorrect or indicator
lights do not illuminate, the LCD gauge must be
replaced.
INSPECTING/SERVICING
(DVX 300)
1. Remove the two self-tapping screws securing the
indicator lamp assembly in the steering post cover.
2. Inspect the bulbs for blackening or burn out.
Replace as required.
Back to Section TOC
KM788A
8
Next
8-7