Steering Post Cover/Instrument Pod - Arctic Cat ATV 300 Utility/DVX 300 2011 Service Manual

For Arctic Cat Parts Call 606-678-9623 or 606-561-4983
5. Install the front center cover; then install the front
and rear racks. Tighten all fasteners securely.
6. Install the battery; then connect the positive battery
cable, negative battery cable, and battery hold-down
strap.
 NOTE: Always install the positive cable first; then
install the negative cable.
7. Install the battery cover; then install the seat making
sure it locks securely in place.
Steering Post Cover/
Instrument Pod
REMOVING (DVX)
1. Remove the two reinstallable rivets on the rear of the
steering post cover; then lift up and push the assem-
bly forward to remove.
2. Disconnect the wire connectors from the indicator
lights and from the ignition switch.
REMOVING (Utility)
1. Remove the reinstallable rivet on the front of the
instrument pod and the two cap screws on the rear;
then lift the assembly off and disconnect the speed-
ometer cable.
2. Remove the self-tapping screw securing the LCD
gauge assembly to the instrument pod; then remove
the LCD gauge.
 NOTE: The LCD gauge is not a serviceable compo-
nent. If any functions are incorrect or indicator lights
KM789A
do not illuminate, the LCD gauge must be replaced.
INSPECTING/SERVICING
(DVX)
1. Remove the two self-tapping screws securing the
indicator lamp assembly in the steering post cover.
2. Inspect the bulbs for blackening or burn out. Replace
as required.
3. Inspect the indicator lamp holder for loose sockets,
broken wires, or loose connections. Replace as
required.
INSPECTING (Utility)
KM788A
The LCD gauge is not a serviceable component. To
inspect the LCD gauge, see Electrical System.
INSTALLING (DVX)
1. Connect the indicator lamp connectors; then connect
the main harness connector to the ignition switch.
2. Place the steering post cover onto the mounting
bracket; then secure with the reinstallable rivets.
INSTALLING (Utility)
1. Connect the main harness connector to the LCD
gauge; then connect the ignition harness to the igni-
tion connectors.
2. Place the instrument pod onto the mounting bracket;
then secure with the reinstallable rivet and two cap
screws.
www.mymowerparts.com
Manual
Table of Contents
111