Table 10-1 Remote Node Bridging Configuration Fields - ZyXEL Communications Prestige 128IMH User Manual

Prestige 128IMH User's Guide
2. Edit IP/IPX/Bridge - Press the space bar to change it to Yes and press ENTER to go
to the network layer options menu as seen below. The accompanying table describes the
pertinent fields (Bridge Options).
Figure 10-1 Remote Node Bridging Configuration
Field
Dial-On-Broadcast
Ethernet Addr
Timeout (min)

Table 10-1 Remote Node Bridging Configuration Fields

Once you have completed filling in the Network Layer Options Menu, press ENTER to
return to menu 11. Press ENTER at the message: 'Press ENTER to Confirm ... 'to save
your selections or press ESC at any time to cancel your selections.
10.3.2.
In Menu 13 - Default Dial-in Setup you must fill out the following parameter for
Bridging applications.
¿ ù » ~ ! © | ¥ ¼ © w ¸ q ¼ Ë ¦ ¡ ¡ C
Menu 11.3 - Remote Node Network Layer Options
IP Options:
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= Yes
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Enter here to CONFIRM or ESC to CANCEL:
Description
This field is necessary for the Prestige on the caller side LAN.
When set to Yes, any broadcasts coming from the LAN trigger the
Prestige to make a call to that remote node. If it is set to No, the
Prestige will not make the outgoing call.
In this field, enter the time (number of minutes) that you wish the
Prestige to retain the Ethernet Address information in its internal
tables while the connection is down. If this information is retained,
then the Prestige will not have to re-negotiate the protocol and
recompile the tables when the connection is brought back up.
Default Dial-In Setup for Bridge
IPX Options:
Dial-On-Query= N/A
Rem LAN Net #= N/A
My WAN Net #= N/A
Hop Count= N/A
Tick Count= N/A
W/D Spoofing(min)= N/A
SAP/RIP Timeout(min)= N/A
Bridge Options:
Dial-On-Broadcast= N/A
Ethernet Addr Timeout(min)=N/A
Page 10-3
ZyXEL