ZyXEL Communications Prestige 128IMH User Manual page 81

Prestige 128IMH User's Guide
network number = 444). A static route is used to resolve this problem by providing the
Prestige with some static routing information to access the remote server.
From menu 12, select one of the four possible IPX Static Routes as shown below:
Figure 9-2 Menu 12.2.1 - Edit IPX Static Route
Field
Server Name
Network #
Node #
Socket #
Type #
Gateway Node
Hop Count
Hop Count
Table 9-1 Fields in Edit IPX Static Route
Once you have completed filling in the menu, press ENTER at the message: Press ENTER
to Confirm ... to save your selections or press ESC at any time to cancel your selections.
¿ ù » ~ ! © | ¥ ¼ © w ¸ q ¼ Ë ¦ ¡ ¡ C
Menu 12.1.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to Confirm or ESC to Cancel:
Description
Enter the name that has been configured for the server. This name must
be the exact name configured in the NetWare server.
This field contains the internal network number of the remote server,
which you wish to access. Do not use 00000000 or FFFFFFFF for this
field.
This field contains the node address of the server. If you are using a
Novell NetWare server, this value is 000000000001.
This field contains the socket number on which the server receives
service requests. The default for this field is hex 0451.
This field identifies the type of service the server provides. The default
for this field is hex 0004.
Enter the number of the remote node that is the gateway for this static
route. (i.e. the remote node that the Prestige needs to call).
This field indicates the number of intermediate networks that must be
passed to reach the remote node. The default is one 1.
This field indicates the time-ticks required to reach the remote node. The
default is two 2.
ZyXEL
Page 9-7