ZyXEL Communications Prestige 128IMH User Manual page 37

Prestige 128IMH User's Guide
determines the type of Ethernet interface you are using as well as the filter sets you wish to
implement to monitor your Ethernet traffic. If you are setting up your network for the first
time, please read Chapter 6 "Configuring the Prestige for Internet Access" before
proceeding. The chapter contains important information on how to assign IP addresses for
your network. There are 4 items in Ethernet Setup.
Figure 4-1 Menu 3 - Ethernet Setup
The first choice for General Setup is shown below. Filter sets are used to block certain
packets to reduce traffic and to prevent a security breach. Filtering is a very involved
subject, so leave these fields blank for the time being. After you have studied filtering in
Chapter 10, come back and define the filter sets. Default values are shown on the screen.
Figure 4-2 General Ethernet Setup
When you are finished, press ENTER at the message: 'Press ENTER to Confirm...' to
save your configuration or press ESC at any time to cancel.
4.4.2.
¿ ù » ~ ! © | ¥ ¼ © w ¸ q ¼ Ë ¦ ¡ ¡ C
Menu 3 - Ethernet Setup
1. General Setup
2. TCP/IP and DHCP Setup
3. Novell IPX Setup
4. Bridge Setup
Enter Menu Selection Number:
Menu 3.1 - General Ethernet Setup
Input Filter Sets:
protocol filters= 2
device filters=
Output Filter Sets:
protocol filters=
device filters=
DHCP
ZyXEL
Page 4-5