Table of Contents
Advertisement
ZyXEL
to the Ethernet Address Timeout parameter in each remote node. When a remote
Ethernet address is aged out, there is no need to maintain its connection to the IPX
server.
From Menu 3 - Ethernet Setup, enter 4 to go to Menu 3.4 - Bridge Ethernet Setup
shown below. Set Handle IPX to None if there is no IPX traffic on the LAN or if you do
not want to apply any special handling for IPX. Set it to Client if there are only client
workstations on the LAN. Set to Server if there are any IPX servers on the LAN.
If there are both clients and servers on the LAN, then the setting depends on if the local
clients will access the remote servers. If they do, set to Client and set Dial-On-Broadcast
in menu 11.2 to Yes to allow the client queries to trigger the call. If they do not, set it to
Server.
Press Space Bar to Toggle.
Figure 10-1 Bridge Ethernet Setup
When you are finished, press ENTER at the message: 'Press ENTER to Confirm ...' to
save your selections or press ESC at any time to cancel them.
10.3.
A typical LAN-to-LAN application is to use the Prestige to call from one office to another
office such that services on one network have access to services on the remote side and vice
versa. You need to configure a remote node in order to dial out to another office.
10.3.1.
Follow the procedure in Chapter 6 to fill the protocol-independent parameters in menu 11,
Remote Node Profile. For the bridging specific parameters, follow the ensuing
instructions:
1. Bridge - Make sure this field is set to Yes.
Page 10-2
Menu 3.4 - Bridge Ethernet Setup
Handle IPX= None
Press ENTER to Confirm or ESC to Cancel:
LAN-to-LAN Application
Remote Node Setup
Prestige 128IMH User's Guide
¿ ù » ~ ! © | ¥ ¼ © w ¸ q ¼ Ë ¦ ¡ ¡ C
Advertisement
Table of Contents
