ZyXEL Communications Prestige 128IMH User Manual page 4

ZyXEL Prestige 128IMH User's Guide
The Industry Canada label identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective, operation and safety
requirements. The Industry Canada does not guarantee that the equipment will operate to a
user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected
to the facilities of the local telecommunications company. The equipment must also be
installed using an acceptable method of connection. In some cases, the company's inside
wiring associated with a single line individual service may be extended by means of a
certified connector assembly. The customer should be aware that the compliance with the
above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance
facility designated by the supplier. Any repairs or alterations made by you to this equipment
or equipment malfunctions, may give the telecommunications company cause to request the
user to disconnect the equipment.
For their own protection, users should ensure that the electrical ground connections of the
power utility, telephone lines and internal metallic water pipe system, if present, are
connected together. This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should
contact the appropriate electrical inspection authority or electrician, as appropriate.
This digital apparatus does not exceed the class A limits for radio noise emissions from
digital apparatus set out in the radio interference regulations of Industry Canada. The
declarations of CE marking:
The Prestige 128IMH has been approved for connection to the Public Switched
Telecommunication Network using interfaces compatible with ITU-TSS recommendation
I.420 (Basic Rate ISDN user access). The Prestige 100IH complies with the following
directives:
1. The Council Directive 89/336/EEC of 3 May 1992 on the approximation of the laws of
the member states relation to Electro Magnetic Compatibility. (EMC Directive).
iv