Table of Contents
Advertisement
ZyXEL
4.3.1.
The Call Waiting feature on your ISDN line works in exactly the same way it does on a
regular analog line (which almost everyone is familiar with). After hearing a call waiting
indicator tone, press and immediately release the flash hook button on your telephone. This
puts your current call on hold and answers the incoming call.
Figure 4-1 ISDN Advance Setup
When you are finished, press ENTER at the message: 'Press ENTER to confirm', the
Prestige uses the information that you entered to initialize the ISDN line. It should be noted
that whenever the switch type is changed, the ISDN initialization takes slightly longer. In
addition, if you are using the U-interface, the system also takes slightly longer to initialize.
At this point, the Prestige asks if you wish to test your ISDN. If you select Yes, the Prestige
will perform a loop-back test to check the ISDN line. If the loop-back test fails, please note
the error message that you receive and take the appropriate troubleshooting action.
Setup LoopBack Test...
Dialing to 40000// ...
Sending and Receiving Data ...
Disconnecting...
LoopBack Test OK
### Hit any key to continue. ###
Figure 4-2 ISDN Loop-back Test Screen
4.4.
4.4.1.
Menu 3 is used to enter Ethernet related information. Depending on the protocols (TCP/IP
or IPX) on your LAN, you will need to configure each protocol separately. This menu
Page 4-4
How to use call waiting
Menu 2.1 - ISDN Advanced Setup
Phone 1 Call Waiting= Enable
Phone 2 Call Waiting= Enable
Calling Line Indication= Presented (CLIP)
Press ENTER to Confirm or ESC to Cancel:
TCP/IP Ethernet Setup and DHCP Menus
Ethernet Setup
Prestige 128IMH User's Guide
¿ ù » ~ ! © | ¥ ¼ © w ¸ q ¼ Ë ¦ ¡ ¡ C
Advertisement
Table of Contents
