ZyXEL Communications Prestige 128IMH User Manual page 62

ZyXEL
Field
Telco Options: CLID
Authen.
PPP Options: Recv.
Authen.
PPP Options: Mutual
Authen.
PAP Login
PAP Password
Multiple Link Options: Max
Trans Rate
Callback Budget
Management: Allocated
Budget (min)
Callback Budget
Management: Period (hr)
Dial-In IP Address Supplied
By: Dial-in User
Dial-In IP Address Supplied
By: IP Pool
IP Pool: IP Start Addr
Page 7-6
Prestige 128IMH User's Guide
Description
There are three choices for this field:None, Required, or
Preferred .
Choices for this field are CHAP/PAP, CHAP , PAP, None.
If the remote node that is dialing in implements mutual
authentication, set this field to Yes.
This field is only enabled if the Mutual Authen.field is set to
Yes. Enter in the login name to be used to respond to the far
end' s PAP authentication request. This field does not apply to
CHAP authentication.
This field is only enabled if the Mutual Authen.field is set to
Yes. Enter in the PAP password to be used to respond to the
far end' s authentication request. This field does not apply to
CHAP authentication.
Enter the maximum data transfer rate between your Prestige
and the remote dial-in user. 64 - At most, one B channel is
used., 128 - A maximum of two channels can be used.. When
the Prestige calls back to the remote dial-in user, the
maximum data transfer rate is always 64
This field sets a ' budget' callback time for all the remote dial-
in users. The default for this field is 0 for no budget control
This field sets the time interval to reset the above callback
budget control.
If set to Yes, it tells the Prestige to allow a remote host to
specify its own IP address. If set to No, the remote host must
use the IP address assigned by the Prestige from the IP pool
configured below. The default is Yes.
This field tells the Prestige to provide the remote host with an
IP address from the pool. This field is required if Dial-In IP
Address Supplied By: Dial-in User is set to No. You can
configure this field even if Dial-in User is set to Yes, in which
case the Prestige accepts the IP address if the remote peer
specifies one; otherwise, an IP address is assigned from the
pool. The default is No.
This field is active only if you selected Yes in the Dial-In IP
¿ ù » ~ ! © | ¥ ¼ © w ¸ q ¼ Ë ¦ ¡ ¡ C