ZyXEL Communications Prestige 128IMH User Manual page 79

Prestige 128IMH User's Guide
the Prestige is configured to receive incoming calls, you can configure the default dial-in
parameters in menu 13 (see Chapter 1).
1. Route - Make sure IPX is among the protocols in the Route field.
2. Edit IP/IPX/Bridge - Press the space bar to change it to Yes and press ENTER to go
to the network layer options menu.
The table below describes the pertinent fields.
Figure 9-1 Menu 11.1 – Remote Node Network Layer Options
Field
Dial-On-Query
Rem LAN Net #
My WAN Net #
Hop Count
¿ ù » ~ ! © | ¥ ¼ © w ¸ q ¼ Ë ¦ ¡ ¡ C
Menu 11.3 - Remote Node Network Layer Options
IP Options:
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= Yes
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Enter here to CONFIRM or ESC to CANCEL:
Description
This field is necessary for the Prestige on the client side LAN. When set
to Yes, query packets coming from the LAN will cause the Prestige to
make a call to that remote node. If it is set to No, the queries will not
cause the Prestige to make the outgoing call.
Enter the internal network number of the NetWare server on the remote
side LAN. The Prestige creates a route to access this server.
Enter the WAN network number of the device that you are connecting
to. Leave this field as 00000000, for the Prestige to negotiate it
automatically between the two devices.
This field indicates the number of intermediate networks that must be
passed to reach the remote node. The default is one 1.
IPX Options:
Dial-On-Query= N/A
Rem LAN Net #= N/A
My WAN Net #= N/A
Hop Count= N/A
Tick Count= N/A
W/D Spoofing(min)= N/A
SAP/RIP Timeout(min)= N/A
Bridge Options:
Dial-On-Broadcast= N/A
Ethernet Addr Timeout(min)=N/A
Page 9-5
ZyXEL