ZyXEL Communications Prestige 128IMH User Manual page 70

ZyXEL
Figure 8-2 Menu 11.3 - Remote Node Network Layer Options
Field
Rem IP Address
Rem IP Subnet Mask
My WAN Addr
Single User Account
Metric
Private
RIP
Version
Table 8-1 Menu 11.3 - Remote Node Network Layer Options
Page 8-4
Menu 11.3 - Remote Node Network Layer Options
IP Options:
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Single User Account= Yes
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Enter here to CONFIRM or ESC to CANCEL:
Description
This shows the IP address you entered for this remote node
in the previous menu.
Enter the subnet mask for the remote network.
Enter the IP address assigned to the WAN port of the
Prestige.
Set this field to Yes to enable the Single User Account
feature when calling this remote node.
IP routing uses hop count as the measurement of cost, with a
minimum of 1 for directly connected networks. The number
need not be precise, but it must be between 1 and 16.
This parameter determines if the Prestige includes the route
to this remote node in its RIP broadcasts. If set to Yes, this
route is kept private and not included in RIP broadcast. If No,
the route to this remote node will be propagated to other
hosts through RIP broadcasts.
Both, In Only, Out Only, or None.
Unless there are routers in your environment that do not
understand RIP-2 packets, you should probably set this field
to RIP-2B. Choices are RIP-2B, RIP-2M or RIP-1 .
Prestige 128IMH User's Guide
IPX Options:
Dial-On-Query= N/A
Rem LAN Net #= N/A
My WAN Net #= N/A
Hop Count= N/A
Tick Count= N/A
W/D Spoofing(min)= N/A
SAP/RIP Timeout(min)= N/A
Bridge Options:
Dial-On-Broadcast= N/A
Ethernet Addr Timeout(min)= N/A
¿ ù » ~ ! © | ¥ ¼ © w ¸ q ¼ Ë ¦ ¡ ¡ C