Operation Setting And The Frequency Setting From The Digital Operator - Hyundai n 700 Instruction Manual

N700 Operating Instructions and Parts Manual
3.2.2

Operation setting and the frequency setting from the digital operator

(Remote operator is also same use.)
(Procedure)
(1) Please make sure that connection is right.
(2) Turn the MCCB on to supply power to the inverter.
(The LED "POWER" on the operator should
(3) Set the operator with the frequency setting selection.
① Set F010 as indication code, press the
(Code values are shown)
② Set 2(OPE KEYPAD) with
setting for the operator. (Indication code turns back to F010.) [Setting method by OPE-
N7 ]
(4) Set the operator with the operation setting selection.
Set F011 as the indication code, press the
Set 2(OPE) with
operator. (Indication code turns back to F011.)
(5) Set the output frequency
① Set F001 as indication code, by pressing the
② Set to the desired output frequency with the
store it.
(6) Set Monitor mode
① When monitoring the output frequency, set indication code to d001, and press
the
② Or when monitoring the operation direction, set indication code to d002, press
the
(In the case of OPE-N7, indication codes are
MCCB
R R
S S
T T
P24
Three phase
PLC
Power Supply
FW
1
2
3
4
5
6
7
8
FM
CM1
H
O
O2
OI
L
Fig. 3- 2 Setting diagram from the digital operator
key, press the
key once.
key once.
U
V
W
Short bar
PD
P
Braking Unit
(BRD)
N
11
12
13
14
AL0
AL1
AL2
RN0
RN1
RN2
G
Earth Ground
illuminate)
key once.
key, press the
key once.
key once to set the frequency setting for the
key once. (Code values are shown.)
key, press the
Forward,
23
3. Operation
Motor
DC reactor
key once to set the frequency
key once to
Reverse, or Stop. )