Hyundai n 700 Instruction Manual page 135

N700 Operating Instructions and Parts Manual
Code
value
FA5
20
Arrival signal 2 setting
frequency
(3) Frequency setting during the acceleration and deceleration is as follows.
Code
Frequency arrival setting
o018
Frequency arrival setting
o019
Frequency arrival setting
o020
Frequency arrival setting
o021
Table 10- 7 Frequency setting during the acceleration and deceleration
(4) The hysteresis frequency for the arrival signal is the following.
① ON : (Setting frequency - 1% of maximum frequency) (Hz)
② OFF : (Setting frequency- 2% of maximum frequency) (Hz)
(5) However in set 06(FA3), 20(FA5) case when inverter accelerates.
① ON : (Setting frequency - 1% of maximum frequency) (Hz)
② OFF : (Setting frequency+ 2% of maximum frequency) (Hz)
(6) When the inverter decelerates.
① ON : ( Setting frequency + 1% of maximum frequency) (Hz)
② OFF : (Setting frequency- 2% of maximum frequency) (Hz)
(7) Output on constant speed arrival (01 : FA1)
① When the arrival at the set frequency with frequency setting(F001) or multi-speed(A027 ~
A042), the output relay is switched.
② The hysteresis of frequency for the arrival signal is as follows.
Fig. 10- 8 Output on constant speed arrival (01 : FA1)
Output
Function name
state
OFF
ON
Table 10- 6 Frequency arrival signal 1~5 (FA 1~FA 5)
Function name
for acceleration
for deceleration
for acceleration 2
for deceleration 2
When the output frequency doesn't reach over Deceleration
arrival frequency in o020 or below Deceleration arrival
frequency in o021.
When the output frequency reaches over Deceleration arrival
frequency in o020 or below Deceleration arrival frequency in
o021.
Initial
Unit Setting range
value
0.00 Hz 0.00~400.0
0.00 Hz 0.00~400.0
0.00 Hz 0.00~400.0
0.00 Hz 0.00~400.0
114
10. Explanation of O-Group
Contents
Contents
0.00~99.99/100.0~400.0
0.00~99.99/100.0~400.0
0.00~99.99/100.0~400.0
0.00~99.99/100.0~400.0
Setting frequency
f : 1% of maximum frequency
on
f : 2% of maximum frequency
off
(ex)
Maximum frequency f
max
Setting frequency f = 60Hz
set
f = 120 × 0.01 = 1.2Hz
on
f = 120 × 0.02 = 2.4Hz
off
Accelerate : ON in 60 - 1.2 = 58.8Hz
Decelerate : OFF in 60 - 2.4 = 57.6Hz
= 120Hz