Explanation Of O-Group - Hyundai n 700 Instruction Manual

N700 Operating Instructions and Parts Manual
10. E
XPLANATION OF
10.1 Intelligent output terminal setting
10.1.1 Intelligent output terminal arrangement
The arrangement and function of intelligent output terminals are as follows.
(1) Layout of control circuit terminals
(2) Output terminal function of N700 inverter control circuit
Item Function
Analog
Monitor
Control
Output
terminal
Digital
Power
Digital
Control
terminal
Monitor
Output
O-
GROUP
Fig. 10- 1 Layout of control circuit terminals
Terminal
Terminal name
marking
Analog monitor
AM
(voltage)
Analog monitor
AMI
(current)
Analog power
L
rotor termination
P24 Interface power
Interface power
CM1
Common
Intelligent Input
PLC
terminal common
Digital monitor
FM
(voltage)
108

10. Explanation of O-Group

Contents
DC 0~10 V voltage output
Output to one selected from monitor items.
4~20 mA electric current output
Output to one selected from monitor items
It is rotor termination of output terminal(AM, AMI).
Note) Don't earth.
It is DC24V power for connection input signal.
When selecting source logic, it's connection input
common.
This is common for DC 24V terminal for interface,
thermister input(TH), Digital monitor(FM).
When sink logic is selected, it is a common point
of contact.
Change sink type and source type by short bar on
control terminals.
P24-PLC : Sink type, CM1-PLC : Source type
In case of driving the connection input by external
power, remove the short cable and connect the
PLC with external interface circuit.
DC 0~10V voltage output(PWM output method)
The selected one of the monitoring function is
displayed.
Output the output frequency to digital pulse(Duty
50%) above monitor.