Custom Parameter Option; Global Parameters - Honeywell MX9 User Manual

Custom Parameter Option

Honeywell does not support the property Custom option. The parameter value is displayed as "Custom" when the
operating system registry has been edited to set the Summit parameter to a value that is not available from the param-
eter's drop down list. Selecting Custom from the drop down list has no effect. Selecting any other value from the drop
down list will overwrite the "custom" value in the registry.

Global Parameters

Parameter
Roam Trigger
Roam Delta
Roam Period
BG Channel Set
DFS Channels
Default
-65 dBm If signal strength is less than this trigger value, the client looks for a
different Access Point with a stronger signal.
Options are: -50 dBm, -55, -60, -65, -70, -75, -80, -85, -90 dBm or Custom.
5 dBm The amount by which a different Access Point signal strength must exceed
the current Access Point signal strength before roaming to the different
Access Point is attempted.
Options are: 5 dBm, 10, 15, 20, 25, 30, 35 dBm or Custom.
BG: 10 The amount of time, after association or a roam scan with no roam, that the
sec. radio collects Received Signal Strength Indication (RSSI) scan data before
A: 5 sec. a roaming decision is made.
Options are: 5 sec, 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 seconds or
Custom.
Full Defines the 2.4GHz channels to be scanned for an AP when the radio is
contemplating roaming. By specifying the channels to search, roaming
time may be reduced over scanning all channels.
Options are:
• Full (all channels)
• 1,6,11 (the most commonly used channels)
• 1,7,13 (for ETSI and TELEC radios only)
• Custom
Off Support for 5GHZ 802.11a channels where support for DFS is required.
Options are: On, Off, Optimized.
Note: Not supported (always off) in some SCU releases.
Function
11 - 15