Setting Speaker Volume; Using The Keypad; Using A Control Panel - Honeywell MX9 User Manual

Setting Speaker Volume

The speaker is located on the front of the MX9 between the Scan keys and underneath the LEDs.
Speaker volume can be adjusted to a comfortable level for the listener by using the keypad or by changing parameters in a
control panel.

Using the Keypad

Note: Speaker sounds must be enabled before the following key sequences can adjust the volume.
The volume is increased or decreased one step each time the volume key sequence is pressed.
To adjust speaker volume:
• Blue+V+Up Arrow and Blue+V+Down Arrow keys on the 62-key keypad.
• Orange+Scan+Up Arrow and Orange+Scan+Down Arrow keys on either keypad.
• Press any key, except the keys you used to adjust the volume, to exit.
Volume control using a keypad key press has six volume settings that match those supported by the control panel. Volume
does not "roll-over" from minimum to maximum or from maximum to minimum. Continuously holding down the up or down
arrow keys does not cause an automatic repeat of the up (or down) arrow key.

Using a Control Panel

Sounds for Events and Programs are enabled by default. Notifications are disabled by default.
1. Tap the speaker icon in the top right corner of the Start screen. A Volume window opens.
2. Move the slider up and down to adjust the speaker volume.
3. If desired, tap the Off radio button to turn sounds off.
2 - 12