Hand Strap; Locking And Unlocking The Mx9; Inserting Or Replacing The Battery Pack; Insert/Replace Battery - Honeywell MX9 User Manual

Hand Strap

Locking and Unlocking the MX9

Note: Review the Unlock process before locking the MX9.
Locking the MX9
The MX9 can be locked manually by tapping Start > Lock. By default, this option is included on the Start screen at the bottom
of the screen. Care should be taken to not accidentally tap this area of the Start screen. Lock can be removed from the Today
screen by selecting Start > Settings > Today > Items. Deselect Device Lock. The MX9 can also be configured to Lock
automatically after a defined period of inactivity. This setting is accessed via Start > Settings > Lock > Password tab. By
default, this option is Disabled. The password and hint are configured by selecting Start > Settings > Lock > Passwords and
Hint.
Unlocking the MX9
When the MX9 is locked, the Start screen displays Unlock at the lower part of the screen.
• If there is no password or PIN set, tap Unlock on the next screen to unlock the MX9. The MX9 is returned to normal operation.
• If there is a password or PIN set, enter the password/PIN and tap Unlock. If several unsuccessful attempts are made, the MX9
may be configured to display a password hint.

Inserting or Replacing the Battery Pack

Warning: Never remove or replace any battery in a hazardous location.
The MX9 will not function unless the battery pack is in place and securely latched.
Be sure to place the unit in Suspend Mode before removing the battery. Failing to properly place the device in Suspend mode
will result in a loss of all unsaved data.
The main battery is located in a compartment on the back of the unit. The battery case serves as the back cover for the battery
well of the MX9.
An MX9 will retain data, while the main battery is removed and replaced with a fully charged main battery, for 5 minutes.
Important: When the internal battery power is Low or Very Low connect the AC adapter to the MX9 before replacing the main
battery.
Note: The battery should not be replaced in a dirty, harsh or hazardous environment. When the battery is not connected to the
MX9, any dust or moisture that enters the battery well or connector may transfer to the battery/well terminals, potentially
causing damage.
Warning. Only use Honeywell batteries as replacements: MX9380BATTERY 161888-0001 or 161915-0001 (Low Temperature)

Insert/Replace Battery

To insert the main battery, complete the following steps:
1. Hand strap connector, upper
2. Stylus holder on Hand strap
3. Hand strap connector, lower
2 - 7