Create A Custom Profile - Honeywell Dolphin CT50 User Manual

HONWedge Profile Commands
Settings
ENABLE_WEDGE
WEDGE_POWER_
TIMEOUT
PREAMBLE
POSTAMBLE
ENTER_DELAY

Create a Custom Profile

You may need to create customized profiles to configure the scanner for your
application. Some settings are only possible when using customized profiles.
The computer uses profiles to enable symbologies, configure symbology options,
and set scanning options.
define or specify one or more profiles and must be placed on the computer in either
of these two locations:
\Documents\Profile
\SharedData\Enterprise\Persistent\Profile
This folder is only accessible by an Enterprise signed application.
To download a sample HoneywellDecoderSettingsV2.exm file, go to
www.honeywellaidc.com, navigate to the CT50 product page, and then select
"Honeywell Decoder Settings Sample EXM File" under the Software listings.
Dolphin CT50 with Windows 10 IoT User Guide
Descriptions
Controls when bar code data is inserted into the keyboard buffer.
While in wedge mode, scanning is disabled and enabled using the
ENABLE_WEDGE profile command.
Use this command to optimize scan performance or to save power.
The WEDGE_POWER_TIMEOUT defaults to 30 ms. After 30 seconds of
inactivity, the scan acquisition system enters a low power state. Press the
scan button to exit the low power state and power up the scan acquisition
system.
The timeout value is set using the WEDGE_POWER_TIMEOUT profile
command. The units are milliseconds.
Adds a prefix to the start of the bar code data.
Adds a suffix at the end of the data to bar code data.
Inserts a delay between bar codes when wedging the bar code data into the
keyboard buffer. A delay of ENTER_DELAY is inserted whenever the Wedge
encounters a carriage return, line feed, or tab key. The units for
ENTER_DELAY are milliseconds.
Some applications, such as Excel, may require additional processing time
when advancing to the next input field. Without a delay, data may arrive
faster than the application can process the data. You can use the
POSTAMBLE command to add a line feed at the end of each bar code.
• The user must create the Profile folder. To learn how to transfer files from
your PC to the mobile computer, see
HoneywellDecoderSettingsV2.exm file is used to
The
Transfer Files,
Default/Units
True (Enabled)
30 ms
200 ms
beginning on page 16.
29