Bluetooth Printer Setup - Honeywell MX9 User Manual

Link unsuccessful
Bluetooth Remote Device LED
LED on Bluetooth Device
Yellow LED blinks at 2 Hz
Off
Yellow LED blinks at 50 Hz
Yellow LED blinks at the same rate as the paging beep (1 Hz)
Green LED blinks once a second
Upon startup, if the remote Bluetooth scanner sounds a long tone, this means the scanner has not passed its automatic Selftest
and has entered isolation mode. If the scanner is reset, the sequence is repeated. Contact
help.

Bluetooth Printer Setup

The Bluetooth managed device should be as close as possible (no more than 32.80 feet [10 meters] line of sight in a quiet
environment) to the MX9 during the pairing process.
1. Open the Bluetooth control panel.
2. Tap Discover. Locate the remote Bluetooth printer in the Discovery panel.
3. Tap and hold the stylus (or double-tap) on the Bluetooth printer until the right-mouse-click menu appears.
4. Select Pair as Printer to pair the MX9 with the Bluetooth managed printer.
The devices are paired. The Bluetooth managed printer may respond with a series of beeps or LED flashes.
Refer to the remote Bluetooth printer manufacturer's User Guide; it may be available on the manufacturer's web site. Contact
Technical Assistance (page 16-1) for Bluetooth product help.
Note: If there is no beep or no LED flash from the remote Bluetooth printer, the MX9 and the printer are currently paired.
7 - 14
Beep will sound high-low-high-low
Behavior
Linking in progress
Disconnected or unlinked
Bluetooth transmission in progress
Paging
Disabled indication
Technical Assistance (page 16-1) for