Setting Terminal Emulation Parameters; Using The Applock Switchpad; Using The Keypad - Honeywell MX9 User Manual

When the Bluetooth LED on the MX9 is on:
• the MX9 is paired with another Bluetooth device but is out of range or not connected, or
• is paired and connected to another Bluetooth device, or
• is discovering other Bluetooth devices.
• The LED blinks slowly (Bluetooth LED is on for one second, off for five seconds) when it is idle.
• The LED blinks quickly (Bluetooth LED is on for 1/4 second, off for 2 seconds when the MX9 is discovering other
Bluetooth devices.
• The LED blinks normally (Bluetooth LED is on for 1/2 second, off for 1/2 second) when it is connected.
There may be audible or visual signals from paired devices as they move back into range and re-connect with the Bluetooth
hardware in the MX9.

Setting Terminal Emulation Parameters

Before you make a host connection, you will, at a minimum, need to know:
• the alias name or IP address (Host Address) and
• the port number (Telnet Port) of the host system to properly set up your host session.
1. Make sure the MX9 network settings are configured and functional. If you are connecting over wireless LAN (802.11
sure your MX9is communicating with the Access Point.
2. From Start > Program, run RFTerm or tap the RFTerm icon on the desktop.
3. Select Session > Configure from the application menu and select the "host type" that you require. This will depend on the
type of host system that you are going to connect to; i.e., 3270 mainframe, AS/400 5250 server or VT host.
4. Enter the "Host Address" of the host system that you wish to connect to. This may either be a DNS name or an IP address of
the host system.
5. Update the telnet port number, if your host application is configured to listen on a specific port. If not, just use the default
telnet port.
6. Select OK.
7. Select Session > Connect from the application menu or tap the Connect button on the Tool Bar. Upon a successful
connection, you should see the host application screen displayed.
To change options such as Display, Colors, Cursor, Bar Code, etc., refer to these sections in the RFTerm Reference Guide for
complete descriptions of these and other features.

Using the AppLock Switchpad

Note: The touch screen must be enabled..
Switchpad Menu
Click the switchpad icon in the taskbar.
A checkmark on the switchpad menu indicates applications currently active or available for Launching by the MX9 user. When
Keyboard, on the Switchpad Menu, is selected, the default input method (Input Panel, Transcriber, or custom input method) is
activated.

Using the Keypad

One switch key sequence (or hotkey) is defined by the Administrator for the end-user to use when switching between locked
applications. This is known as the Activation key.
When the Activation key sequence is pressed on the keypad, the next application in the AppLock configuration is moved to
the foreground and the previous application moves to the background. The previous application continues to run in the
background. MX9 key presses affect the application in focus only.
Switchpad Icon
x
), make
2 - 15