Spare Battery Led; Mx9 System Status Led Status When Docked; Docking And Undocking The Mx9; Dock The Mx9 - Honeywell MX9 User Manual

Spare Battery LED

When Spare LED is ...
Off
Green
Red
Yellow / Amber
Flashing Red
Note: Spare battery charging does not require an MX9 be docked in the docking bay.

MX9 System Status LED Status when Docked

The MX9 System Status LED is located at the top of the keypad.
When the LED is . . .
Blinking Red
Steady Red
Blinking Green
No Color

Docking and Undocking the MX9

When the MX9 is in Suspend Mode it wakes up when it is docked in a powered cradle. There is no change in mode state
settings or behavior when the MX9 is docked in a cradle without a power source.
MX9 mode states while the MX9 is in a powered cradle e.g., suspend, resume, display backlight, etc., are managed by the
MX9 OS Power settings.
If the cradle is not permanently attached to the work surface, stabilize the cradle with one hand while inserting or removing
the MX9 with the other hand.
The MX9 is inserted into the charging pocket with the keypad facing forward.

Dock the MX9

Remove any cables attached to the I/O port in the base of the MX9.
Carefully press the MX9 straight down into the docking bay until the multi-pin connector at the base of the MX9 clicks
into place with the multi-pin charging/communication connector at the bottom of the docking bay. The MX9 cradle is
designed to secure the MX9 facing front.
The cradle's Docked LED illuminates.

Undock the MX9

Remove the MX9 from the cradle by pulling it straight up and out of the docking bay. If necessary, brace the cradle with
one hand while the other hand removes the MX9.
The cradle's Docked LED turns Off.

Inserting / Removing a Spare Battery from the Desktop Cradle

Prerequisites: The steps outlined in
dle has a dependable power source. The cradle has been bolted to a stable surface, if desired.
Note: Do not drop or slam the spare battery into the charging pocket. Damage may result.
14 - 8
It means ....
Battery pack not inserted or no power applied
Battery pack fully charged
Battery pack charging
Battery pack temperature out of range
Battery pack fault or failure
The Status is . . . Comment
Power Fail Replace the main battery with a fully charged main
battery.
Or
Connect the MX9 to external AC power to allow the
internal charger to charge the main battery e.g., dock in a
powered cradle.
Main Battery Low Low Battery Warning. Replace the main battery with a fully
charged main battery. Or dock the MX9 in a powered
cradle.
Display Off No user intervention required.
Good No user intervention required.
Assemble/Attach the AC Power Adapter (page 14-6) have been completed and the cra-