Battery Charger Help - Honeywell MX9 User Manual

NO LIGHT - on all charge pockets
No light means there is no AC power available for the battery charger or there is power but there are no batteries in any
charging bay.

Battery Charger Help

The following is intended as an aid in determining whether the battery pack or the charger may be malfunctioning:
Issue
Battery pack does not fit in charging
pocket.
No battery pack in charger, but any of the
LEDs are on.
Charger is plugged into a live outlet,
battery pack is inserted, but RED LED is
OFF and no other LEDs are on, or all
LEDs are off.
Charger is plugged into a live outlet,
battery pack is inserted, but RED LED is
OFF and no other LEDs are on, or all
LEDs are off.
Charger is plugged into a live outlet,
battery pack is inserted, but RED LED is
OFF and no other LEDs are on, or all
LEDs are off.
When you first put a fully charged battery
pack in the charging pocket, the RED
LED comes on, indicating the battery
pack is charging.
LED is flashing RED at any pocket.
LED is flashing RED at any pocket.
13 - 6
Cause
Different manufacturer's battery
pack, or there is an object in the
charging pocket.
Dirt or foreign objects are in the
charging pocket.
Battery pack is not making
contact with battery charge
terminals in the charging pocket.
Faulty battery pack.
New battery pack, same result.
During the first few minutes, the
battery charger checks the
battery pack for correct voltage
and charge state. During this time
the LED is RED and is
continuously ON. After charging
is complete, the LED is GREEN.
Current could not be sourced
through the battery pack due to
age, exhaustion or damage to the
cell(s). The battery pack does not
communicate with the charger.
The charger's timeout period has
expired.
Solution
Check if the MX9 battery pack has
Honeywell part number MX9380BATT or
MX9381BATT (Low Temperature) on the
label. If not, do not use.
Remove the object from the charging
pocket.
Unplug charger from AC supply. Remove
any dirt or foreign objects from the
charging pocket. If the LEDs continue to
remain ON, the charger may be defective.
Return charger to an authorized
Honeywell service center.
Push battery pack in firmly. Do not "slam"
the battery pack into the charging pocket.
Replace battery pack.
Contact Customer Support
replacement options.
There is nothing wrong with the battery
pack or charger.
Do not "top off" a fully charged battery
pack by repeatedly placing it in the
charging pocket. The battery pack may
overheat and be damaged.
Contact Customer Support
battery pack replacement options.
Make sure that the battery pack
temperature is within specification and
retry charging. Contact Customer Support
(page 16-1) if problem repeats, for battery
pack replacement options.
(page 16-1) for
(page 16-1) for