Using Remote Management; Using Express Scan; Creating Bar Codes; Scanning Bar Codes - Honeywell MX9 User Manual

Using Remote Management

1. Configure the radio to connect to the network running the Mobile Device Server. After the MX9 is connected, proceed to
step 2.
2. If it is desired to configure the radio using the Summit package, add the configured package to the Wavelink Avalanche MC
Console and enable it.
3. Verify RMU.CE.CAB exists in the \System\RMU folder.
4. Double click the MX9 enabler CAB file in the \System folder.
5. The enabler automatically launches after installation and contacts the Mobile Device Server. The Avalanche MC Console
connected to that Mobile Device Server identifies the remote device and performs a sync. This downloads any available
packages available for the MX9.

Using eXpress Scan

eXpress Scan Desktop Icon
If the MX9 has an eXpress Scan icon on the desktop, eXpress Scan may be used for the initial configuration of the device.
If the eXpress Scan icon is not present on the desktop, install the Enabler. If the icon is still not present, the Enabler must be
updated.
If the eXpress Scan icon is present, follow these steps to configure the MX9 to connect with the wireless network and the Mobile
Device Server.

Creating Bar Codes

Barcodes are created with the eXpress Config utility on the desktop/laptop computer, not the mobile device. Depending on
the bar code length and the number of parameters selected, eXpress Config generates one or more bar codes for device
configuration. The bar codes contain configuration parameters for the wireless client in the mobile device and may also
specify the address of the Mobile Device Server.
Barcodes should be printed at a minimum of 600 dpi.

Scanning Bar Codes

Follow these instructions for each device to be configured.
1. Start eXpress Scan on the MX9 by double clicking the eXpress Scan icon.
2. Enter the bar code password, if any.
10 - 20