I/O Port; Vehicle Cradle Strain Relief Cable Clamp - Honeywell MX9 User Manual

I/O Port

1. Squeeze the clips next to the connector attached to the I/O cable to open the catches in the connector.
2. Firmly press the cable end (female) into the I/O Port connector (male) at the back of the cradle. Release the clips in
the connector cable. Test the connection for stability.
3. Secure the cable to the cradle with the

Vehicle Cradle Strain Relief Cable Clamp

Equipment Required: Phillips screwdriver (not supplied by Honeywell)
There are two strain relief cable clamps secured to the back of the vehicle cradle. They are located at the back of the cradle,
below the trigger handle opening.
1. Remove the strain relief cable clamp from the back of the cradle by turning the screw counterclockwise. Put the screw
aside in a safe location.
2. Slide the strain relief clamp over the cable.
3. Using a Phillips screwdriver and the screw that was removed, refasten the clamp holding the cable to the vehicle cradle.
Do not stretch the cable. Leave enough slack in the cable to allow the cable to be connected and disconnected from the
MX9 easily when needed.
4. Continue in this manner until all cables are secured to the back of the vehicle cradle.
Vehicle Cradle Strain Relief Cable Clamp (page 14-23).
14 - 23