Leds, Backlights And Indicators; Status Leds; System Status Led; Battery Charging Status Led - Honeywell MX9 User Manual

The main battery can be recharged while it is in the MX9:
• by connecting the MX9 AC power adapter to the I/O connector at the base of the MX9.
• by docking the MX9 in a powered desk cradle
• by docking the MX9 in a powered vehicle cradle
• or by connecting the car power adapter (CLA) to the I/O connector at the base of the MX9.
Note: An uninterrupted external power source (wall AC adapters) transfers power to the computer's internal charging circuitry
which, in turn, recharges the main battery and internal battery. Frequent connection to an external power source, if
feasible, is recommended to maintain internal battery charge status as the internal battery cannot be recharged by a dead
or missing main battery.

LEDs, Backlights and Indicators

Status LEDs

Several LEDs are located on the front of the MX9 above the speaker. They are:
• System Status (SYS) LED indicates power management status (far left LED).
• Battery Charging Status (BATT) LED indicates main battery charging status (far right LED).
• Alpha Mode Status LED applies to the 38-key keypad only (LED is next to SYS LED).
• Bluetooth Status LED applies to Bluetooth client functions (LED is next to BATT LED).

System Status LED

Blinking Red
Solid Red
Yellow / Amber

Battery Charging Status LED

Off
Flashing Red
Yellow / Amber
Red
Green

Alpha mode Status LED

• Green when in alpha mode, 38-key keypad only.

Bluetooth Status LED

• Blue when Bluetooth activated
• Off when Bluetooth not activated.

Keypad Backlight Setting

The keypad backlight is white and can be set to be on or off. The default value is on.
When set to off, the keypad backlight does not turn on during Suspend/Restart or reboots.
When set to on, the keypad backlight follows the display backlight settings. The keypad backlight turns off when the display
backlight dims.

Toggle Vibrate Indicator

The MX9 vibration motor is activated when a scan is completed successfully (good scan vibration) or with a failure (scan
key released before good scan, timeout, or rejected because of Data Options configuration).
The vibrations can be detected under the hand strap or through the trigger handle.
Toggle the vibrate indicator on or off by tapping the desired radio button for Good Scan Vibration and Bad Scan Vibration.
Battery power fail; critical suspend
Main battery low
Initial few seconds when Power key is pressed
No battery, no AC power, battery pack not plugged in or no AC power applied
Fault, battery pack fault or failure
Standby, battery pack temperature out of range
Charging, battery pack charging (icon on touch screen)
Charged, battery pack fully charged. Connected to external power.
2 - 9