Custom Parameter Option; Global Parameters - Honeywell MX8 User Manual

Custom Parameter Option

The Custom option is not supported. The parameter value is displayed as "Custom" when the operating system
registry has been edited to set the Summit parameter to a value that is not available from the parameter's drop down
list. Selecting Custom from the drop down list has no effect. Selecting any other value from the drop down list will
overwrite the "custom" value in the registry.

Global Parameters

Parameter
Roam Trigger
Roam Delta
Roam Period
BG Channel Set
DFS Channels
10 - 14
Default Function
-65 dBm If signal strength is less than this trigger value, the client looks for a different Ac-
cess Point with a stronger signal.
Options are: -50 dBm, -55, -60, -65, -70, -75, -80, -85, -90 dBm or Custom.
5 dBm The amount by which a different Access Point signal strength must exceed the cur-
rent Access Point signal strength before roaming to the different Access Point is
attempted.
Options are: 5 dBm, 10, 15, 20, 25, 30, 35 dBm or Custom.
BG: 10 sec. The amount of time, after association or a roam scan with no roam, that the radio
A: 5 sec. collects Received Signal Strength Indication (RSSI) scan data before a roaming
decision is made.
Options are: 5 sec, 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 seconds or Custom.
Full Defines the 2.4GHz channels to be scanned for an AP when the radio is contem-
plating roaming. By specifying the channels to search, roaming time may be re-
duced over scanning all channels.
Options are:
Full (all channels)
1,6,11 (the most commonly used channels)
1,7,13 (for ETSI and TELEC radios only)
Custom.
Off Support for 5GHZ 802.11a channels where support for DFS is required.
Options are: On, Off.
Note: Not supported (always off) in some releases.