Adjusting The Shock Absorber; Assembly - Yamaha AG200FEM 2021 Owner's Manual

Adjusting the shock absorber

assembly

This shock absorber assembly is
equipped with a spring preload adjust-
ing ring.
NOTICE
To avoid damaging the mechanism,
do not attempt to turn beyond the
maximum or minimum settings.
Adjust the spring preload as follows.
1. Remove the seat. (See page 4-8.)
2. To increase the spring preload and
thereby harden the suspension,
turn the adjusting ring in direction
(a). To decrease the spring pre-
load and thereby soften the sus-
pension, turn the adjusting ring in
direction (b).

Align the appropriate notch in
the adjusting ring with the posi-
tion indicator on the shock ab-
sorber.

Use the special wrench includ-
ed in the owner's tool kit to
make the adjustment.
EAU36465
1
2
3
4
(a)
5
ECA10102
2
1. Special wrench
2. Position indicator
Spring preload setting:
Minimum (soft):
1
Standard:
1
Maximum (hard):
5
3. Install the seat.
WARNING
This shock absorber assembly con-
tains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.

Do not tamper with or attempt to
Instrument and control functions

1
(b)


EWA10222
4-9
open the cylinder assembly.
Do not subject the shock ab-
sorber assembly to an open
flame or other high heat source.
This may cause the unit to ex-
plode due to excessive gas
pressure.
Do not deform or damage the
cylinder in any way. Cylinder
damage will result in poor
damping performance.
Do not dispose of a damaged or
worn-out shock absorber as-
sembly yourself. Take the shock
absorber assembly to a Yamaha
dealer for any service.
1
2
3
4
5
6
7
8
9
10
11
12