Table of Contents
Advertisement
High Speed Pan/Tilt System
4
Installing the High Speed Pan/Tilt
This chapter outlines the procedures needed to install the High Speed Pan/Tilt. Installation
should only be done by qualified service personnel in conformance to all local codes.
4.1
Mounting the High Speed Pan/Tilt
The High Speed Pan/Tilt System can be mounted with either a wall mount (MTC-WUPH, sold
separately) or pole mount (MTC-PUPH, sold seperately).
To install the device, proceed as follows:
1.
2.
Fig. 4.1 Optional Wall Mount (1) or Pole Mount (2)
Bosch Security Systems
NOTICE!
i
The High Speed Pan/Tilt unit cannot be mounted upside down! This will stress
bearings and mechanical components; no liabilities are accepted and all
warranties are void.
Determine the location to install the device.
–
When selecting a location, a minimum clearance of 300 mm (12 in.) in front of the
unit and 300 mm (12 in.) in back of the unit is required to facilitate component
removal and installation.
–
The device should be installed vertically. Any other position could impair the perfor-
mance of the device.
–
Do not attach the device upside down.
Insert the cables into the optional wall or pole mount so they protrude approximately
.5 m (19.7 in.) (see Figure 4.1).
.5 m
19.7 in.
MTC-WUPH
WARNING! Medium Risk:
!
The cables should not be accessible by unauthorized personnel; cables should be
secured to fixed locations at appropriate intervals to bare the weight of the
cables, e.g. cables running inside a tall camera pole.
1
Instruction Manual
Installing the High Speed Pan/Tilt | en
.5 m
19.7 in.
MTC-PUPH
F01U.073.990 | Version 1.0 | 2007.07
11
2
Advertisement
Table of Contents
