Setting Serial Interface; Power-On Confi Guration - Custom Engineering PLUS II User Manual

1. INSTALLATION AND USE

1.3.2 Setting serial interface

See paragraph 1.2.2.
1.3.3 Power-On confi guration
The JP8 jumper on controller board (see Fig.1.6) manages the power-on setting function as indicated:
The printer switches on when powered up, and it switches off when power is off (default
• If JP8 is closed:
condition). In this condition the ESC '0' command has not effects.
When the printer is powered up the low-consumption mode is activated. An impulse of at
• If JP8 is open:
least 500 m/sec on pin 6 of the serial RS232 connector must be given to switch on the printer (see par.
2.2.1 and table 2.2). Use ESC "0" command to switch off the printer and bring it back to low-consumption
mode.
Refer to Fig. 1.6 for the JP8 jumper position.
JP8
CLOSE=AUTO
OPEN=EXTERNAL
JP8 JP8
1-6 PLUS II
User Manual
CLOSED
OPEN
JUMPER
SELECTION
POWER-ON
JUMPER JUMPER
SELECTION SELECTION
POWER-ON POWER-ON
CLOSE=AUTO CLOSE=AUTO
OPEN=EXTERNAL OPEN=EXTERNAL
J8
Auto Power-On enabled
Auto Power-On disabled
JUMPERS
SELECTION
INTERFACE
(Fig.1.6)
RS232
TTL