Front Position Lamp Bulb Removal And Installation; Side Repeater Lamp Bulb Removal And Installation - Jeep Cherokee 2000 Service Manual

8L - 6 LAMPS
REMOVAL AND INSTALLATION
FRONT POSITION LAMP BULB . . . . . . . . . . . . . . . 6
SIDE REPEATER LAMP BULB . . . . . . . . . . . . . . . . 6
REMOVAL AND INSTALLATION
FRONT POSITION LAMP BULB
REMOVAL
(1) Remove the 2 screws holding the headlamp
bezel in place and remove bezel (Fig. 1).
Fig. 1 Headlight Bezel Retaining Screws
(2) Remove the 4 screws holding the headlamp
(Fig. 2).
Fig. 2 Headlamp Retaining Screws
LAMP BULB SERVICE
TABLE OF CONTENTS
page
headlamp (Fig. 3).
socket.
INSTALLATION
socket.
ring and install the retaining screws.
ing screws.
SIDE REPEATER LAMP BULB
REMOVAL
straight from the fender.
(Fig. 4).
REAR FOG LAMP BULB . . . . . . . . . . . . . . . . . . . . 7
LICENSE PLATE LAMP BULB . . . . . . . . . . . . . . . . 7
(3) Pull the front position lamp straight from
Fig. 3 Front Position Lamp Grommet & Socket
Location
1 – GROMMET
2 – SOCKET
(4) Remove the front position lamp bulb from
(1) Install the front position lamp bulb in lamp
(2) Verify lamp operation.
(3) Install front position lamp in headlamp.
(4) Connect headlamp electrical connector.
(5) Position the headlamp, headlamp retaining
(6) Position the headlamp bezel and install retain-
(1) Grip the side repeater lamp assembly and pull
(2) Rotate and pull the socket from the housing
(3) Pull the bulb straight from the socket.
XJ
page