Service Interval Display - Skoda Yeti Owner's Manual

Switch on/off and adjust the light duration of the Com-
Coming Home ing Home function. Further information
COMING HOME / LEAVING HOME.
Switch on/off and adjust the light duration of the Com-
Leaving Home ing Home function. Further information
COMING HOME / LEAVING HOME.
Enable / disable the daytime running lights. Further in-
Dayl. dri. light formation
LIGHT).
Switch on/off the function for automatic rear window
Rear wiper wiping. Further information
window wiping.
Switch on/off the convenience flashing function. Fur-
Lane ch. flash ther information
nal".
Switch on/off the travel model function. Further infor-
Travel mode
mation » page
Factory setting Restore the factory setting for the lighting.
Time
The time, time format (12 or 24 hour indicator) and the changeover between sum-
mer/winter time can be set here.
Winter tyres
Here, the speed and the switching on and off of the acoustic signals when ex-
ceeding this speed can be adjusted. This function is, for example, used for winter
tyres where the maximum permissible speed is lower than the maximum speed of
the vehicle » page 212, Tyres and wheel rims.
As soon as the parking procedure is completed, an audible signal sounds and the
following message appears in the information display.
Winter tyres: max. speed ... km/h.
Units
The units for the temperature, consumption and distance driven can be set here.
Assistants
The tones of the audible signals for the parking aid can be adjusted here.
Further information » page 140, Parking aid.
1)
For models with the speedometer in mph, the second speed is displayed in km/h.
30
Using the system
» page
» page
» page 48, Daylight running lights (DAY
» page 57, Automatic rear
» page 49, "Convenience turn sig-
50, Tourist lights (Travel mode).
Alt. speed dis.
Here, the display of the second speed in mph
51,
Further information
Service
51,
The days and kilometres remaining until the next service can be displayed here.
Further information
Factory setting
The factory setting of the functions of the MAXI DOT display can be restored here.

Service interval display


Introduction
This chapter contains information on the following subjects:
Prompt in the segment display
Prompt in the MAXI DOT display
Before the next service interval is reached, a message concerning the kilometres
and days remaining until the next service is due is shown for about 10 seconds
after the ignition is switched on.
This information can also be displayed manually with the ignition at all times.
The kilometre indicator or the days indicator reduces in steps of 100 km or, where
applicable, days until the service due date is reached.
Note
Information is retained in the Service Interval Display even after the vehicle bat-
■
tery is disconnected.
If the instrument cluster is exchanged after a repair, the correct values must be
■
entered in the counter for the Service Interval Display. This work is carried out by
a specialist garage.
In some national versions the displays appear in the Imperial system of meas-
■
urement.
For more information on the service intervals, see
■
can be activated.
1)
» page 13, Display of the second speed.
» page 30, Service interval display.
» page

31
31
182, Service intervals.
