Skoda Yeti Owner's Manual page 245

The protective grille must engage firmly.
CAUTION
For vehicles with parking assistance, we recommend that after changing the light
bulb in the fog lights, the system is checked by a specialist.
Replacing the bulb for the licence plate light
Fig. 201 Remove the number plate light/replace the bulb

First read and observe the introductory information and safety warn-
ings on page 238.
›
Open the boot lid.
›
Push in the lamp in the direction of the arrow
The lamp comes loose.
›
Swivel out the lamp in the direction of the arrow
›
Remove the faulty bulb from the holder in the direction of the arrow
›
Insert a new bulb into the holder.
›
Reinsert the lamp in the opposite direction to the arrow
›
Push on the light until the spring clicks into place.
Check that the light is securely inserted.
242
Do-it-yourself

» Fig. 201.
1
and remove it.
2
.
3
.
1

Rear light
Fig. 202 Remove light / pull out connector

First read and observe the introductory information and safety warn-
ings on page 238.
Removing
›
Open the boot lid.
›
Unscrew the light » Fig. 202 using the Torx key from the car tool kit
Vehicle tool kit.
›
Grasp the light and carefully remove with shaky movements in the direction of
arrow .
1
›
Dis23connect the plug connection by pressing the catches in direction of arrow
» Fig. 202 and by pulling them in direction of arrow
2
Installing
›
Insert the connector into the light and lock it securely.
›
Insert the light into the mounts in the body
Fig. 203
Install light
» page 220,
.
3
» Fig. 203.
