System Settings - Skoda Yeti Owner's Manual

The air inlet in front of the windscreen must be free (e.g. of ice, snow or leaves)
■
to ensure that the auxiliary heating (aux. heating) operates properly.
So that warm air can flow into the vehicle interior after switching on the auxili-
■
ary heating, you must maintain the comfort temperature normally selected by
you, leave the fan switched on and leave the air outlet vents in an open position.
It is recommended putting the air flow in the position  or .
Switching on and off directly
Fig. 96 Button for switching on/off the system directly on the operating
part of the air conditioning/Climatronic

First read and observe the introductory information and safety warn-
ings on page 97.
The auxiliary heating (auxiliary heating and ventilation) can be directly switched
on or off at any time using the button
of the air-conditioning system , on the operating part of the Climatronic system
or via the radio remote control.
If the auxiliary heating and ventilation has not already been switched off, it
switches off automatically after the running time set in the Running time menu.
After switching off the auxiliary heating, the coolant pump runs for a short period.
98
Using the system
» page 99 » Fig. 96 on the operating part

System settings


First read and observe the introductory information and safety warn-
ings on page 97.

The following menu items can be selected from the Aux. heating menu item in
the MAXI DOT display (depending on the vehicle equipment):
Day of the wk. - set the current day of the week
■
■ Running time - Set the required running time in 5 minute increments. The run-
ning time can be 10 to 60 minutes.
Mode - Set the desired heating/ventilation mode
■
■ Starting time 1, Starting time 2, Starting time 3 - for each pre-set time, the day
and the time (hour and minute) can be set for switching on the auxiliary heating
and ventilation. An empty position can be found between Sunday and Monday
when selecting the day. If this empty position is selected, the activation is per-
formed without taking into account the day.
Activate - Activate pre-set mode
■
■ Deactivate - Deactivate pre-set mode
Factory settings - Restore factory settings
■
Back - Return to main menu
■
Only one programmed pre-set time can be active.
The last programmed pre-set time remains active.
After the auxiliary heating activates at the set time, it is necessary to pre-set a
time again.
If the pre-set menu is closed by selecting the Back menu item or if no changes
are made on the display for more than 10 seconds, the set values are stored, but
the pre-set time is not activated.
An indicator light on the button  is illuminated when the system is running.
The running system deactivates after expiration of the operating period or can be
deactivated earlier by pressing the button to directly switch on/off the auxiliary
heating  or by using the radio remote control.

