Table of Contents
Advertisement
Securing the loading floor in the raised position
First read and observe the introductory information and safety warn-
ings
on page 88.
›
Fold up the hooks on the fastening strip in direction of arrow
page 84.
›
Fold up the variable loading floor behind the rear back backrests.
›
Fold down the hooks in direction of arrow
stop.
›
Support the variable loading floor on the hooks folded downwards
Removing and refitting carrier rails
Fig. 89 Slacken check points/remove carrier rails
Fig. 88
Secured loading floor in the
raised position
» Fig. 80
on
1
» Fig. 80
on page 84 as far as the
3
» Fig.
88.
First read and observe the introductory information and safety warn-
ings
on page 88.
Removing
›
Slacken the check points
B
a flat screwdriver.
›
Hold the carrier rail
in the front area and remove by pulling in the direction of
A
arrow
.
1
›
Hold the carrier rail
in the rear area and loosen and remove by pulling in the
A
direction of arrow
.
2
Install
›
Position the carrier rails on the sides of the boot.
›
Press the two securing points
›
Check the attachment of the carrier rails by pulling it.
WARNING
Pay attention when installing the variable loading floor that the carrier rails
and the variable loading floor are correctly fixed, otherwise the occupants are
at risk.
» Fig. 89
on the carrier rails using the vehicle key or
» Fig. 89
on each carrier rail to the stop.
B
Seats and useful equipment
89
Advertisement
Chapters
Table of Contents
