›
Carefully press the light into the body so that the bolts
page 243 or
» Fig. 205
on page 243 on the light engage into the mounts on the
body.
›
Screw the light with the screws
» Fig.
Replacing bulbs in rear light
Fig. 204 Inner part of the light: Ground light
Fig. 205 Inner part of the light: Light with LED diodes
First read and observe the introductory information and safety warn-
ings
on page 238.
Ground light
›
With the Torx screw, unscrew the securing screw
›
Unlock the bulb holder using the locking latches marked with arrows
and remove the bulb holder from the light.
» Fig. 204
on
1
202into place.
» Fig. 204
.
A
» Fig. 204
›
Turn the respective bulb
B
move it from the bulb holder.
›
Insert a new bulb
into the holder and turn in a clockwise direction to the
B
stop.
›
Pull bulb
» Fig. 204
out of the socket and insert a new bulb.
C
›
Insert the bulb holder in the light.
All locking mechanisms must audibly snap into place.
Light with LED diodes
›
Unlock the bulb holder using the locking latches marked with arrows
and remove the bulb holder from the light.
›
Turn the respective light bulb
move it from the bulb holder.
›
Insert a new bulb into the holder and turn in a clockwise direction to the stop.
›
Insert the bulb holder in the light.
All locking mechanisms must audibly snap into place.
Note
Visit a specialist garage if an LED diode is faulty.
» Fig. 204
until it stops counter-clockwise and re-
» Fig. 205
until it stops counter-clockwise and re-
Fuses and light bulbs
» Fig. 205
243