The Following Message Is Shown In The Maxi Dot Display; Warning; Lights » Page 52. The Warning Triangle Must Be Set Up At The Prescribed Dis; Handbrake - Skoda Yeti Owner's Manual

Hide thumbs Also See for Yeti:
Table of Contents

Advertisement

Turn signal system
 
Fog lights
Cruise control system
Selector lever lock
OFF ROADmode
Main beam
The warning lights indicate certain functions or faults.
Some warning lights can be accompanied by acoustic signals and messages in the
display of the instrument cluster.
After switching on the ignition, some warning lights illuminate briefly as a func-
tion test.
If the tested systems are OK, the corresponding warning lights go out a few sec-
onds after switching on the ignition.

WARNING

Ignoring illuminated warning lights and related messages or instructions in
the display of the instrument cluster may lead to serious personal injury or
damage to the vehicle.
If you have to stop for technical reasons, then park the vehicle at a safe dis-
tance from the traffic, switch off the engine and switch on the hazard warning
lights
» page
52. The warning triangle must be set up at the prescribed dis-
tance - observe the national legal provisions when doing so.
The engine compartment of your car is a hazardous area. The following
warning instructions must be followed at all times when working in the en-
gine compartment
» page
199, Engine compartment.

Handbrake

First read and observe the introductory information and safety warn-
ings
on page 14.
The indicator light
comes on if the handbrake is applied.
An acoustic signal will sound if you drive the vehicle above 6 km/h for at least 3
seconds while the handbrake is applied.

The following message is shown in the MAXI DOT display.

Release parking brake!
21

Brake system

22
22
First read and observe the introductory information and safety warn-
22
ings
on page 14.
22
If the warning light
lights up, the brake fluid level in the brake system is too
22
low.
The following message is shown in the MAXI DOT display.
Brake fluid: Owner's manual!
Stop the vehicle, switch off the engine, and check the level of the brake flu-
id
» page
206.
If the warning light
lights up together with the warning light , there is a
problem with the ABS.
WARNING
If you have to stop for technical reasons, then park the vehicle at a safe dis-
tance from the traffic, switch off the engine and activate the hazard warning
light system
» page
52. The warning triangle must be set up at the prescri-
bed distance - observe the national legal provisions when doing so.
The following guidelines should be observed when opening the bonnet and
checking the brake fluid level
If the warning light
is displayed simultaneously with warning light
» page
19,
Antilock brake system (ABS),
ney! Seek help from a specialist garage.
A fault to the braking system can increase the vehicle's braking distance -
risk of accident!

Seat belt warning light

First read and observe the introductory information and safety warn-
ings
on page 14.
The warning light
comes on after the ignition is switched on as a reminder for
the driver and front passenger to fasten the seat belt.
The warning light
goes out once the driver or front passenger has fastened
their seat belt.
» page
199, Engine compartment.
do not continue your jour-
Instruments and Indicator Lights
15

Advertisement

Table of Contents
loading

Table of Contents